Every system starts with the controller. Add sensors for your air and water, pumps for dosing, and a relay module for equipment.
How ordering works now. The product is at prototype stage, so you reserve rather than buy: add parts to your basket and send a reservation request. Nothing is charged. We reply with the configuration, the price and the delivery date, and you decide whether to go ahead.
What the design assumes for a single room with a two-part nutrient and pH correction. Adjust it in the basket, or describe your room and we size it with you.
The main unit with built-in WiFi gateway. Pumps plug in along one side, sensors along the other.
The case in the pictures is the planned design. Its size, material and rating, and the power supply, are to be confirmed.
Temperature, humidity, CO₂ and light for one room.
Sensors read on a bench controller. Number of light sensors per room to be confirmed.
Measure your nutrient solution: pH, EC, dissolved oxygen, ORP, temperature and level.
Probes not yet tested on the controller. Base kit versus options to be confirmed.
One pump with its own driver in a small case. Up to ten per controller: eight nutrient, two pH.
Pump model and motor voltage not chosen yet. The driver's case is the planned design.
Switches lights, fans, heater, humidifier, dehumidifier and irrigation.
Module and contact rating not chosen. Mains wiring must be done by an electrician.
A configured set for your room, sized with us: controller, sensors, pumps and relays.
Offered through the early-access programme first.
Package contents are proposed from the engineering design and may change. Status labels show how far each part has come; see the status page.
The controller's RJ45 sockets carry power and control signals. Never connect them to a network port.
Tell us your room and equipment and we will size it with you.
